Vozidlo na zber odpadu

Mercedes-Benz Econic 2630 6x2 RHD Faun refuse truck

Stav: nový, maximálna hmotnosť nákladu: 30 740 kg, celková hmotnosť: 40 000 kg, konfigurácia náprav: > 3 nápravy, Rok výroby: 2026, * T 4: * Wabco EBS-E (electronic braking system) * RDÜ tire pressure monitoring system * Emergency release device for spring brake cylinders * Drum brakes * 4 x 11 t Gigant axles * Air suspension with lifting and lowering system and RtR valve * Smard-Board for payload determination * Warning sign kits front & rear Njdsl Tik Nepfx Algslh * Reflective contour markings on the sides and rear * Removable rear rotating beacon * LED lighting * Straight drawbar with 50 mm towing eye and stepless height adjustment * Toolbox made of powder-coated sheet steel and basket-type spare wheel holder, right side * Front: closed single plastic mudguards * Rear: straight steel mud flaps with spray suppression * Side underrun protection * Turntable platform extended by 520 mm with 45° corners and 3 recessed lockable storage compartments including lids * Chassis made of high-strength fine-grain steel * Decking over turntable platform: 50 mm softwood, and on low-bed platform: 60 mm softwood * Outer planks of the loading ramps made of hardwood * Four stake pockets on each side (stakes not included) with simultaneous 2 t lashing option * Lashing package: two 6.4 t lashing eyes front left and right on the main frame of the turntable platform * On the outer frame, two pairs front and rear of 13.4 t lashing rings each, and four pairs per side of 10 t swivel and lowerable lashing rings * Loadable in all directions and integrated in the outer frame * Two pairs of 6.4 t lashing rings on the excavator arm rest, side * 8 pairs of galvanized folding outriggers for 3 m total width (not on rear slope) * Widening planks stored on the left side in a storage compartment * Excavator arm rest above the rear axle to the end of the loading slope approx. 2,100 x 740 x 190 mm * Mechanical drop supports at the rear * Hydraulic folding ramps with hydraulically extendable tip, approx. 4,650 x 720 mm, incl. hydraulic lateral ramp adjustment & load holding valve * Loading area above turntable: approx. 2,990 x 2,520 mm * Rear loading area: approx. 6,780 x 2,520 mm * Loading height, loaded: approx. 890 mm, +/- 20 mm (incl. 860 mm loading slope) * Flow divider installed * Chassis, turntable, loading ramps, folding outriggers, and mechanical drop supports hot-dip galvanized * Axles, drawbar, air tank, and turntable painted in black * Tires: 235/75 R 17.5 * New vehicle without previous registration with manufacturer's warranty * Subject to errors and prior sale * Immediately available from Egestorf near the A7