Nízkozdvižný príves

MÜLLER-MITTELTAL T4, Luftfed., hydr. Klapprampe, Baggerstiel.

Stav: nový, celková hmotnosť: 40 000 kg, maximálna hmotnosť nákladu: 30 740 kg, konfigurácia náprav: 3 nápravy, Rok výroby: 2026, * T 4: * Wabco EBS-E (electronic braking system) * RDÜ tyre pressure monitoring system * Emergency release device for spring-loaded cylinders * Drum brakes * 4 x 11 t Gigant axles * Air suspension with lifting and lowering system, and RtR valve * Smard on-board system for load weight determination * Warning sign packages front and rear * Contour tape reflective, on the sides and rear * Rotating beacon (removable) at the rear * LED lighting * Straight drawbar with 50 mm towing eye and continuously adjustable height * Toolbox made of powder-coated sheet steel and spare wheel carrier in basket design, mounted on the right side Lhsdpel Tik Nofx Agkjn * Front: closed individual plastic mudguards * Rear: straight steel mudflaps, each with spray suppression * Side underrun protection * Bogie platform extended at the front by 520 mm with 45° corners and 3 integrated lockable storage compartments with lids * Chassis made of high-strength fine-grained steel * Floor over bogie platform: 50 mm softwood, and on low-bed platform: 60 mm softwood * Outer planks of the loading ramps are hardwood * 4 stake pockets per side (stakes not included), each with 2 t lashing capacity * Load securing package: 2 lashing eyes (6.4 t) at the front left and right on the main frame of the bogie platform * 2 pairs of lashing rings 13.4 t per side, front and rear on the outer frame, and 4 pairs of lashing rings 10 t per side, foldable and lowerable * Loadable in all directions and integrated into the outer frame * 2 pairs of lashing rings 6.4 t on the side in the excavator stick rest * 8 pairs of galvanized folding outriggers for 3 m total width (not at the rear slope) * Widening planks stored in a compartment on the left side * Excavator stick rest above the rear axle to the end of the approach slope approx. 2,100 x 740 x 190 mm * Mechanical rear support legs * Hydraulic folding ramps with hydraulically adjustable tip section approx. 4,650 x 720 mm including hydraulic side ramp shift & load holding valve * Loading area above slewing ring: approx. 2,990 x 2,520 mm * Rear loading platform: approx. 6,780 x 2,520 mm * Loading height loaded approx. 890 mm, +/- 20 mm (including 860 mm approach slope) * Flow divider installed * Chassis, bogie, loading ramps, folding outriggers, and mechanical support legs, hot-dip galvanized * Axles, drawbar, air tank, and slewing ring painted in black * Tires 235/75 R 17.5 * New vehicle without first registration, with manufacturer's warranty * Subject to prior sale and errors * Available from week 07/2025